Sponsored
Water softeners for hard water
Very hard water. Whole-house softeners are the high-ticket fit; salt and test kits support the install.
Dawson Creek Drinking Water Quality
By OpenStats · Built from official Canadian sources
Regional estimateB
Water quality grade
Good
Graded against Health Canada drinking water guidelines
Lead within guidelinepH in range
Hardness vs provincial average215 mg/L · prov. avg 139 mg/L
Lead vs provincial average0.7 μg/L · prov. avg 0.3 μg/L
Hardness
215 mg/L
Lead
0.7 μg/L
≤ 5 μg/L
pH
7.8
6.5–8.5 range
Hardness
215 mg/L
Very hard
Lead
0.7 μg/L
Max: 5 μg/L
pH
7.8
6.5–8.5
Chlorine
1.2 mg/L
Max: 4 mg/L
From source to sink
Where Dawson Creek water comes from
Lakes, rivers, wells, and treatment plants behind the kitchen tap, in plain language. Chemistry grades above are a separate lab snapshot; this section is the route the water travels.
Open the full tap storyOn the map
Where Dawson Creek water lives
Source waters and treatment plants pinned from published utility names. Open a pin below for the full OpenStreetMap view.
- CityDawson Creek
Municipal service area
- Treatment plantDawson Creek Water Treatment Plant (Class IV)
Approximate pin near Dawson Creek (exact plant coordinates pending)
Map data © OpenStreetMap contributors. Pins are approximate for orientation, not legal survey points.
Where it starts
Surface water
Research confidence: high
Named source waters
- Kiskatinaw River (intake at Arras)
Treatment plants
Dawson Creek Water Treatment Plant (Class IV)
Coagulation, filtration, chlorination, GAC; UV also reported. Capacity about 14,500 m³/day. Raw water travels ~16.5 km through Hansen, Hart, and Trail off-stream reservoirs.
How it reaches your street
Serves Dawson Creek, Pouce Coupe, Rolla, and rural customers. Reservoirs provide roughly 200 days of storage.
SponsoredAlso consider
Whole-house water softener
Best for hardness ≥ 180 mg/L
SponsoredAlso consider
Water hardness test strips
Confirm mg/L before sizing a unit
As an Amazon Associate, OpenStats earns from qualifying purchases.
Partner
Lab water test for Dawson Creek taps
Municipal reports cover the plant. A Tap Score kit tests the water at a Dawson Creek tap for a broader contaminant panel.
Lab kit partner link. We may earn a commission when tracking is active.
Reading this page
Dawson Creek's most recent drinking water sample (2026-07-22) reports hardness of 215 mg/L, classified as very hard, and pH 7.8, drawn from a groundwater water source and treated at Dawson Creek Water Treatment Plant. Lead measured 0.7 μg/L and fluoride 0.6 mg/L.
Free chlorine measured 1.2 mg/L in this sample. No E. coli was detected in this sample.
Dawson Creek's hardness of 215 mg/L is above the British Columbia average of 139 mg/L across 31 tracked municipalities, with a provincial average pH of 7.5.
These readings summarize a single compliance snapshot, not a certification of the water reaching your tap. Test your own water periodically, especially on a private well, and consider a softener if hardness is classified hard or very hard.
How to use this page: read the headline metrics first, then where the water comes from (map and tap story), then the parameter table and source footer.
Health parameters meet Health Canada limits; turbidity above the 1 NTU typical target and very hard water.
Health parameters meet Health Canada limits; turbidity exceeds the typical 1 NTU aesthetic target.
Figure 1 · From source to sink
How drinking water reaches your tap
Compared to provincial average
British Columbia · 31 cities in sample
Hardness (city vs British Columbia avg)215 mg/L
pH (city vs British Columbia avg)7.8
Lead (city vs British Columbia avg)0.7 μg/L
Fluoride (city vs British Columbia avg)0.6 mg/L
Provincial average: hardness 139 mg/L · pH 7.5 · lead 0.3 μg/L · fluoride 0.6 mg/L
Full parameters
| Parameter | Reading | Health Canada guideline | Status |
|---|---|---|---|
| Hardness | 215 mg/L | No health limit (aesthetic) | Compliant |
| pH | 7.8 | 6.5–8.5 | Compliant |
| Lead | 0.7 μg/L | ≤ 5 μg/L | Compliant |
| Fluoride | 0.6 mg/L | ≤ 1.5 mg/L | Compliant |
| Chlorine (free) | 1.2 mg/L | ≤ 4 mg/L | Compliant |
| Turbidity | 1.6 NTU | ≤ 1 NTU (typical target) | Exceeds guideline |
Alberta water licences
WaterRegister.ca
On a private well or holding an Alberta water allocation licence? Water Register maps EPA licence records, transfer comparables, and watershed context across the province.
Explore WaterRegister.ca →Water softeners for hard water
Very hard water. Whole-house softeners are the high-ticket fit; salt and test kits support the install.
As an Amazon Associate, OpenStats earns from qualifying purchases.
· Compare options- Shop on Amazon.caWhole-house water softenerBest for hardness ≥ 180 mg/L
- Shop on Amazon.caSoftener saltOngoing supply (high repurchase)
- Shop on Amazon.caWater descalerScale reduction without salt
- Shop on Amazon.caWater hardness test stripsConfirm mg/L before sizing a unit
- Shop on Amazon.caTDS meterQuick dissolved-solids check
Source · ECCC / municipal open data (seed). Last updated 2026-07-22. Refreshed on the site's automated schedule.