Water softeners for hard water
Very hard water. Whole-house softeners are the high-ticket fit; salt and test kits support the install.
By OpenStats · Built from official Canadian sources
Direct municipal dataWater quality grade
Good
Graded against Health Canada drinking water guidelines
From source to sink
Lakes, rivers, wells, and treatment plants behind the kitchen tap, in plain language. Chemistry grades above are a separate lab snapshot; this section is the route the water travels.
Open the full tap storyOn the map
Source waters and treatment plants pinned from published utility names. Open a pin below for the full OpenStreetMap view.
Municipal service area
Buffalo Pound
Approximate pin near Regina (exact plant coordinates pending)
Map data © OpenStreetMap contributors. Pins are approximate for orientation, not legal survey points.
Surface water
Research confidence: high
Buffalo Pound Water Treatment Plant
Non-profit corporation jointly owned by Regina and Moose Jaw since 1955 (corporate form since 2016). Treats Buffalo Pound Lake water; plant sits about 30 km northeast of Moose Jaw. Undergoing a major renewal project.
Treated water is pumped over 60 km into Regina’s five reservoirs; three city pumping stations pressurize more than 900 km of water mains (city materials also cite an extensive network of over 2,000 km of pipe in broader system descriptions).
Very hard water. Whole-house softeners are the high-ticket fit; salt and test kits support the install.
Best for hardness ≥ 180 mg/L
Confirm mg/L before sizing a unit
As an Amazon Associate, OpenStats earns from qualifying purchases.
Municipal reports cover the plant. A Tap Score kit tests the water at a Regina tap for a broader contaminant panel.
Lab kit partner link. We may earn a commission when tracking is active.
Regina's most recent drinking water sample (2026-07-22) reports hardness of 208 mg/L, classified as very hard, and pH 7.8, drawn from a surface water source and treated at Regina Water Treatment Plant. Lead measured 0.5 μg/L and fluoride 0.5 mg/L.
Free chlorine measured 1 mg/L in this sample. No E. coli was detected in this sample.
Regina's hardness of 208 mg/L is above the Saskatchewan average of 196 mg/L across 10 tracked municipalities, with a provincial average pH of 7.5.
These readings summarize a single compliance snapshot, not a certification of the water reaching your tap. Test your own water periodically, especially on a private well, and consider a softener if hardness is classified hard or very hard.
How to use this page: read the headline metrics first, then where the water comes from (map and tap story), then the parameter table and source footer.
All monitored parameters meet Health Canada guidelines.
Health parameters compliant; minor aesthetic factors such as hardness or pH near guideline edges.
Figure 1 · From source to sink
How drinking water reaches your tap
Saskatchewan · 10 cities in sample
Provincial average: hardness 196 mg/L · pH 7.5 · lead 0.5 μg/L · fluoride 0.6 mg/L
| Parameter | Reading | Health Canada guideline | Status |
|---|---|---|---|
| Hardness | 208 mg/L | No health limit (aesthetic) | Compliant |
| pH | 7.8 | 6.5–8.5 | Compliant |
| Lead | 0.5 μg/L | ≤ 5 μg/L | Compliant |
| Fluoride | 0.5 mg/L | ≤ 1.5 mg/L | Compliant |
| Chlorine (free) | 1 mg/L | ≤ 4 mg/L | Compliant |
| Turbidity | 0.6 NTU | ≤ 1 NTU (typical target) | Compliant |
On a private well or holding an Alberta water allocation licence? Water Register maps EPA licence records, transfer comparables, and watershed context across the province.
Explore WaterRegister.ca →Very hard water. Whole-house softeners are the high-ticket fit; salt and test kits support the install.
As an Amazon Associate, OpenStats earns from qualifying purchases.
· Compare options